Review of New ver Zero Hammer
Review of the New version
TM G17 Zero Hammer:
Compared with two version,we cut the green area and build up the pink area.
left:TM Stock hammer,middle:old ver zero hammer ,right: New Ver Zero Hammer.
The reason cause the TM stock hammer and old ver zero hammer not smooth is
this 1.2mm high step of the nozzle carrier. It cause the nozzle carrier contact to the
hammer base before it contact to the hammer roll(TM stock) or hammer rotor(Old ver Zero hammer)(Marui has been fix this problem on G18C,and hammer stop point ,cancel this step already.)
This pic shows where the nozzle carrier contact to the hammer base.
This pic shows New Ver Zero Hammer cut the green area , and it will not
touch the nozzle carrier any more. Now distance from the rotor touch point to the
hammer base is quite longer than 1.2mm. Even the rotor used for a long time it
will not touch the nozzle carrier.
New stop area , instead of old ver B line either TM A line.It make the
hammer do not need to run in ,just drop and go.
Build up the pink area make the fire pin goes forward then TM stock or old ver
zero hammer. It will increase the durable and FPS.
This pic show white line is the tm stock fire pin goes and old version zero hammer do.
Now you can see , new version zero hammer makes the fire pin goes a little forward.
After we get the feedback from player ,we change the
sear point / rotor angle again , made the hammer lock from sear earlier than old ver. Makes the gun more durable.
Hammer rotor as a wear and tear parts , it can be purchased
separately.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Below is the New Zeor Hammer working pic: